![]() The device operates on two 1.5 V AA batteries (not included). When installing the camera at the top of your license. Out of the box, the mount is assembled for installing the camera at the bottom your license plate. When the mount is installed on your vehicle, the Garmin logo on the camera clip must be right-side up. Installing the Camera at the Top of Your License Plate Insert the license plate screws through the mount and into the mounting holes in your vehicle.If you are installing the mount with the camera at the top of the license plate, you must remove, rotate, and reattach the camera clip (Installing the Camera at the Top of Your License Plate, page 2). NOTE: You can install the mount in either orientation. The camera mount provides a variety of holes and slots for universal vehicle compatibility. Place the camera mount against your vehicle, and align the holes in the mount with the license plate mounting holes in your vehicle.Remove the rear license plate and license plate holder from your vehicle, and retain the license plate screws to install the camera mount.Vehicle Mount Installation for Europe Installing the Mount on Your Vehicle You must fasten the mount and license plate to the vehicle using at least two license plate screws, whether or not you attach the mounting tape. NOTE: The mounting tape does not replace the license plate screws. You can stack two layers of mounting tape if one layer is not thick enough to stick to your vehicle. This helps reduce camera vibration, especially if your vehicle does not provide mounting holes at the bottom of the license plate. The mounting tape secures the back of the mounting bracket to your vehicle using double-sided adhesive. Apply one or two layers of the included adhesive mounting tape to the back of the flat mounting bracket, near the bottom (optional).Insert the two camera clip screws into the holes labeled.Rotate the camera clip 180 degrees, so the Garmin logo is facing right-side-up.Using a Phillips screwdriver, fully loosen the two camera clip screws, and remove the camera clip from the metal bracket.This allows you to properly adjust the camera angle. When installing the camera at the bottom of your license plate, you must remove, rotate, and reattach the camera clip. Out of the box, the camera mount is assembled for installing the camera at the top of your license plate. To allow for proper camera angle adjustment, the Garmin® logo on the camera clip must be right-side up when the mount is installed on your vehicle. Installing the Camera at the Bottom of Your License Plate Install license plate screws through the bottom holes of the license plate, and tighten (optional).This option is not available for all vehicles or for all mounting bracket positions.Fully tighten the license plate screws. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |